Translate this page









Project Vehicles


Good Morning all,

Now that the car is back at High Speed Welding Joe is going to modify the lower spring mount. The goal was to move the lower bar over and not cut into the original frame rail. He came up with this great solution. Since Ride-Techs bars are already offset we only needed to move the bar over about 1/2 to 3/4 of an inch to get it inside the inner wheel tub.

Marty McGuire's Second Chance - 1970 Camaro Build

 


 

Good Morning all,

For the rear suspension I upgraded to the Ride-Tech Coil Over set up. However we've added a few new
parts that Ride-Tech offers. First is there offset lower link bar and offset spring mount which gives you an
extra 3/4" of tire room. There will be plenty of room to fit the BFG 295 (12.5" wide) and most 315's.

Marty McGuire's Second Chance - 1970 Camaro Build

There new Coil overs - what else do I need to say.

Marty McGuire's Second Chance - 1970 Camaro Build

 


 

BBT Fab New Front Spoiler & Rocker Extensions
www.2ndchancecamaro.com

Good Morning all,

I dropped the car off on Friday the 16th at BBT Fab in Champaign, IL www.bbtfab.com with Troy for a couple modifications.

After seeing the work that he has been doing on the 69 Firebird I wanted him to make similar rocker extensions for my car.

Yesterday Troy posted a few pictures of the Camaro. It's starting to take shape and once the car is back on the ground I am sure it will look even "more better" <--- my daughters favorite two words.

Firewall Modification
The guys removed some of the unnecessary holes and put blind nuts in the firewall for the DSE Close Out Panel.

Marty McGuire's Second Chance - 1970 Camaro Build

 


 

Finishing Up the Mini-Tub Install
www.2ndchancecamaro.com
 
Good Morning all,

The guys at High Speed finished off the install of the Mini-Tubs

Mario did a such great job cutting out the original tubs it made short work for the guys.

Marty McGuire's Second Chance - 1970 Camaro Build

 


 

Installing the Ride Tech Rear Brackets
www.2ndchancecamaro.com

Good Evening all,

While the car was at High Speed Welding the guy's flattened the passenger side bracket to match this cars
floor pan. Very simple tweak that had to be done. Even though these parts are meant to be bolt-on some-times
they require a little work to fit better.

Marty McGuire's Second Chance - 1970 Camaro Build